Exhaust Gas Temperature Sensor 4 -G648-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the bolts -1-, loosen the bolt -2- and remove the turbocharger heat shield.

Fig 1: Identifying Bolts -1 To 2- And Turbocharger Heat Shield

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the connector -4- from the bracket and disconnect it.

Fig 2: Installed Location for the Exhaust Cleaning System Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Free up the wiring guide for the Exhaust Gas Temperature Sensor 4 -G648-.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the Exhaust Gas Temperature Sensor 4 -G648- -arrow-.

Fig 3: Identifying Exhaust Gas Temperature Sensor 4 -Arrow-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.