Exhaust Gas Temperature Sensor 3 -G495-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications. Refer to EXHAUST GAS TEMPERATURE SENSOR .

Install in reverse order of removal while noting the following:

NOTE:

Coat the Exhaust Gas Temperature Sensor 3 -G495- threads with hot bolt paste. For the correct hot bolt paste. Refer to the Parts Information.

Note installation position:

Fig 1: Installed Position & Dimension A

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -a- = 10 mm between Exhaust Gas Temperature Sensor 3 -G495- -2- and the coolant line -1-.

-- Install the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .