Engine Coolant Temperature Sensor -G62-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening specification. Refer to OVERVIEW - COOLANT PIPES .

NOTE:

Replace the O-rings.

To prevent coolant loss, immediately turn new Engine Coolant Temperature Sensor -G62- into the thread.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts Information.

-- Check the coolant level.