Upper Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - COOLANT PIPES .

Install in reverse order of removal while noting the following:

NOTE:

Replace the O-ring.

During installation, all cable ties must be installed at the same location.

-- Clean or smooth O-ring sealing surface before installing.

-- Coat the O-ring with coolant and slide it onto the coolant pipe.

-- Install the right lower section of the intake manifold. Refer to INTAKE MANIFOLD LOWER SECTION WITH FUEL RAIL, REMOVING AND INSTALLING .

-- Install the high pressure pipe. Refer to HIGH PRESSURE PIPE, REMOVING AND INSTALLING .

-- Install the compressor. Refer to SUPERCHARGER, REMOVING AND INSTALLING .

-- Fill with coolant for the high temperature coolant circuit. Refer to COOLANT, DRAINING AND FILLING, HIGH TEMPERATURE CIRCUIT .