Adaptive Suspension Valve Block -NX7-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note the following:

Prior to installation of the air line, ensure that only the second marking -arrow B- on the air line is visible.

Fig 1: Front Air Line Installation Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The distance -a- from the end of the air line to the cutting ring -1- must be between 4 mm and 6 mm.

Connector assignment for the air lines at the Adaptive Suspension Valve Block -NX7- :

Fig 2: Adaptive Suspension Valve Block Air Lines Connector Assignment

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Black, drain line
Blue, internal air line between the Adaptive Suspension Valve Block -NX7- and the compressor
Yellow, Air Line to the Right Rear Air Spring Shock Absorber
Violet, Air Line to the Left Front Air Spring Shock Absorber
Red, Air Line to the Left Rear Air Spring Shock Absorber
Green, Air Line to the Right Front Air Spring Shock Absorber
Black, Air Line from the Compressor to the Pressure Reservoir

-- Fill the pressure reservoir with the Vehicle Diagnostic Tester. Refer to PRESSURE RESERVOIR, FILLING .