Steering Column Electronics Control Module -J527-, Removing And Installing: Notes

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

The Airbag Spiral Spring/Return Spring with Slip Ring -J527- and the Steering Angle Sensor -F138- are integrated in the Steering Column Electronics Control Module -G85-.

NOTE:

Code the new Steering Column Electronics Control Module -J527- after installing it. Refer to STEERING COLUMN ELECTRONICS CONTROL MODULE -J527-, CODING .

If the steering column switch is faulty, then perform an output diagnostic test for the Steering Column Electronics Control Module -J527-.

The Steering Column Electronics Control Module -J527- can be checked via the output diagnostic test.

The Airbag Spiral Spring/Return Spring with Slip Ring -J527- and the Steering Angle Sensor -F138- are integrated in the Steering Column Electronics Control Module -G85-.

-- Remove the steering column switch module. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

NOTE:

Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.

-- Remove the bolt -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the hooks -arrows- and remove the Steering Column Electronics Control Module -J527- -2- from the steering column switch module -3-.

-- Unlock and disconnect the connectors from the Steering Column Electronics Control Module -J527- -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position a screwdriver, as illustrated, on the hooks -2 and 4- and carefully unlock the connectors -1 and 5- in direction of -arrow A-.

-- Remove the Steering Column Electronics Control Module -J527- from the steering column switch module.