Spray Nozzle Holder, Removing And Installing: Installing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the spray nozzle bracket to adjust how far the cap on the nozzle is pulled into the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.
-- Slide spray nozzle holder into lift cylinder until it engages.
-- Remove the cap on the spray nozzle holder and lower the lift cylinder.
-- Check cover cap for correct seating on bumper cover.
-- Adjust the cap if necessary by shifting the spray nozzle holder into a higher or lower catch on the lift cylinder.
-- Bleed headlamp washer system after completing assembly work. Refer to HEADLAMP WASHER SYSTEM, BLEEDING .