Front Final Drive, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

A second technician will be needed to install the front final drive back into the mounts on the subframe.

-- Install the bolts and nuts -1 through 3- that connect the front final drive -A- to the subframe -B-. Refer to SUBFRAME .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the drive axle to the flange shafts. Refer to DRIVE AXLE ASSEMBLY .

-- Install the front driveshaft. Refer to FRONT DRIVESHAFT, REMOVING AND INSTALLING .

-- Remove the Tensioner Hooks (2 pc.):VW552 .

-- Install the left and right front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Check the transmission fluid level in the front final drive. Refer to FRONT FINAL DRIVE, CHECKING TRANSMISSION FLUID .

-- Install the impact guard under the front final drive, if equipped. Refer to appropriate service information .

-- Install the front wheels. .

-- If necessary, perform a vehicle alignment after the installation is complete. .