Camshaft Position Sensor: Notes

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

For the locations of the four camshaft position sensors. Refer to COMPONENT LOCATION OVERVIEW .

-- Disconnect the electrical connector on the respective camshaft position sensor.

NOTE:

The following camshaft position sensors are installed in cylinder bank 1 (right): Camshaft Position (CMP) Sensor -G40- and Camshaft Position (CMP) Sensor 3 -G300-

The following camshaft position sensors are installed in cylinder bank 2 (left): Camshaft Position (CMP) Sensor 2 -G163- and Camshaft Position (CMP) Sensor 4 -G301-

-- Remove the air filter housing to remove the Camshaft Position (CMP) Sensor 3 -G300- on cylinder bank 1.

-- Remove the coolant reservoir to remove the Camshaft Position (CMP) Sensor 4 -G301- on cylinder bank 2.