LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1196 (Crankshaft, Cylinder Block [CFSA] (Coupe)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following: 

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

-- Pay Attention To The Alignment Pin When Installing The Sensor Wheel And Drive Plate.

-- Turn the Counterhold - Flywheel:10-201  to tighten the bolts.

scientia non olet · About LEMON Manuals