Overview - Crankshaft: Notes
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For assembly work, secure the engine on the Engine And Transmission Holder:VAS6095 . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Cylinder Block
- Paired to -12-
- Sealant Applied On Cylinder Block (For Guide Frame). Refer To Figure
- Seals
- Replacing
- Shaft Seal
- For Crankshaft - Belt Pulley Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Alignment Sleeve
- Quantity: 2
- Insert Into Guide Frame
- Installed Position. Refer to Figure
- Bolt
- 9 Nm
- Guide Tube
- For The Oil Dipstick
- O-Ring
- Replacing
- Bolts
- For Guide Frame
- Replacing
- There Are Different Bolt Sizes
- Tightening Specification And Sequence. Refer To Figure.
- Baffle Plate
- Bolt
- Replacing
- Tightening Specification And Sequence. Refer To Figure.
- Bolt
- For Guide Frame To Cylinder Block Sealing Surfaces
- There Are Different Bolt Lengths
- Tightening Sequence. Refer To Figure
- Guide Frame
- Paired To -1-.
- Sealant Applied On Cylinder Block (For Guide Frame). Refer To Figure
- Thrust Washer
- Only On Crankshaft Bearing 4
- Installed Position: Lubricating Grooves Face Outward
- Note Locating Point In Guide Frame
- Bearing Shell
- For Guide Frame Without Lubricating Groove
- Always Replace If Removed
- Install The New Bearing Shells For The Guide Frame With The Correct Color Identification: New Crankshaft. Refer To MAIN BEARING SHELLS, NEW CRANKSHAFT, ALLOCATING , Worn And Reworked Crankshaft. Refer To MAIN BEARING SHELLS, USED AND REWORKED CRANKSHAFTS, ALLOCATING
- Crankshaft
- Axial Play, Measuring. Refer To CRANKSHAFT, MEASURING AXIAL CLEARANCE .
- Radial Play, Measuring. Refer To CRANKSHAFT, MEASURING RADIAL CLEARANCE .
- Crankshaft Dimensions. Refer To CRANKSHAFT DIMENSIONS .
- Thrust Washer
- Only On Crankshaft Bearing 4
- Installed Position: Lubricating Grooves Face Outward
- Bearing Shell
- For Cylinder Block With Oil Groove
- Always Replace If Removed
- Install The New Bearing Shells For The Cylinder Block With The Correct Color Marking: New Crankshaft. Refer To MAIN BEARING SHELLS, NEW CRANKSHAFT, ALLOCATING , Worn Or Reworked Crankshaft. Refer To MAIN BEARING SHELLS, USED AND REWORKED CRANKSHAFTS, ALLOCATING
- Seals
- Replacing