Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

NOTE:

Replace The Seals And Self-Locking Nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts. Refer to Figure.

Fig 1: Exhaust Manifold Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install The Right Catalytic Converter: For Vehicles With Manual Transmissions/Manual Transmission 0AW. Refer To RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING . For Vehicles With The Automatic Transmission 0B6 Or Automatic Transmission 0B6. Refer To RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install The Plenum Chamber Bulkhead. Refer To OVERVIEW - PLENUM CHAMBER BULKHEAD .

-- Install The Heated Oxygen Sensor -G39-. Refer To HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .

-- Install The Noise Insulations. Refer To OVERVIEW - PLENUM CHAMBER BULKHEAD .

-- Install The Front Wheel. Refer To WHEEL, CHANGING AND MOUNTING .