Engine Coolant Temperature Sensor -G62-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Tightening Specification. Refer To OVERVIEW - COOLANT PIPES .

NOTE:

Replace The O-Ring.

To Prevent Coolant Loss, Immediately Insert New Engine Coolant Temperature Sensor -G62- In The Connections.

-- Check The Coolant Level. Refer To CHECK THE COOLANT LEVEL .