Fuel Level Sensor 1: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Proceed As Follows:
-- Observe Safety Precautions SAFETY PRECAUTIONS .
-- Observe Rules For Cleanliness CLEAN WORKING CONDITIONS .
NOTE:
During Installation, The Cable Ties Must Be Re-Installed At The Same Location.
-- Removing fuel delivery unit FUEL DELIVERY UNIT .
-- Disconnect electrical connector -4- by pressing release -arrow-.
-- Cut Through Cable Ties -2- And Free Up Electrical Connector.
-- Release Retaining Tabs -1- And -3- And Remove Fuel Level Sensor -G- Upward.