Clean Working Conditions
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Even A Little Contamination Can Lead To Faults. When Working On The Fuel Supply And Fuel Injection System, Observe The Following Guidelines For A Clean Working Environment:
- Thoroughly Clean All Connections And The Surrounding Area Before Disconnecting.
- Immediately Seal Off Lines And Connections With Clean Plugs Or Protective Caps.
- Place Parts That Have Been Removed On A Clean Surface And Cover Them. Use Lint-Free Cloths.
- Carefully Cover Over Opened Components Or Seal, If Repairs Are Not Performed Immediately.
- Only Install Clean Components: Only Unpack Replacement Parts Immediately Prior To Installation. Do Not Use Parts That Have Been Stored Outside Of Their Original Packaging (E.G. In Tool Boxes Etc.).
- When The System Is Open: Do Not Work With Compressed Air. Do Not Move Vehicle Unless Absolutely Necessary.
- Protect Disconnected Electrical Connectors From Dirt And Moisture And Only Connect If Dry.