EVAP Canister: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Proceed As Follows:

-- Observe Safety Precautions SAFETY PRECAUTIONS .

-- Observe Rules For Cleanliness CLEAN WORKING CONDITIONS .

-- Remove Left Rear Underbody Cover. Refer To UNDERBODY TRIM PANEL .

-- Disconnect Electrical Connector -6-.

Fig 1: Identifying EVAP Lines, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove air line -5-.

-- Remove vent line -7-.

-- Disconnect vent line -9- to evaporative emission (EVAP) canister purge regulator valve -N80- by pressing release button.

-- Disconnect vent line -2- to fuel tank by pressing release button.

-- Remove bolts -1, 4 and 8- and remove EVAP canister -3-.