Sunroof Frame, Removing And Installing, Sedan
It Is Necessary To Code Or Program The Mechanical Components Or Control Modules On The Panorama Sunroof After Removing And Installing Them Using Guided Functions In Guided Fault Finding Under Diagnostic Address 46 Using The Vehicle Diagnostic Tester.
- Bolt
- 3 Nm
- Power Sunroof Control Module -J245-
- Performing the adaptation procedure. Refer to MOTOR ADAPTATION .
- Bolt
- 8 Nm
- Roof
- Panorama Sunroof Frame
- Removing
-- Move the front seat backrests to the rear.
-- Only lower the headliner. Refer to HEADLINER, REMOVING AND INSTALLINGRoof Trim Panels .
-- Disconnect the connectors.
-- Remove the front and rear water drain hoses.
NOTE:The Side And Center Screws On The Frame Remain Mounted Until The End.
Two Technicians Must Hold The Frame Before The Screws Can Be Removed And The Frame Removed.
-- Remove the screws except for the left and right center screws.
-- Holding the frame with a second technician, first loosen the center bolts and then lift the frame out through the opening in the roof.
- Installing
-- Lightly secure the frame with the bolts.
-- Disconnect the frame at the securing holes using an 8 mm diameter drill bit at the front and rear. Refer to Attaching Points for the Frame .
-- Tighten the screws first at the front and then at the rear to the tightening specification.
-- Tighten the screws longitudinally alternating from rear to front to the tightening specification.
-- Install the front and rear water drain hoses on the frame.
- Removing
- Sun Shade
- Removing. Refer to SUNROOF SHADE, REMOVING AND INSTALLING .
- Roof Shade Control Module -J394-
- Performing the adaptation procedure. Refer to MOTOR ADAPTATION .