Reading, Measured Value Block 32

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Warning information for the high voltage system:

For procedures where the ignition must be switched on, refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .

NOTE:

Applies to certain countries only. Refer to the Maintenance table.

DTC memory not erased.

NOTE:

The measured values needed will be erased when the DTC memory is cleared.

Bank 1 measured value (4-cylinder engine) and bank 1 and bank 2 measured values (V6 and V8 engines) are monitored.

-- :VAS 50XX/60XX Connecting. Refer to Vehicle Diagnostic Tester .

-- Select Guided Functions.

-- Select brand and type.

-- Select the engine electronics or the name of the injection and ignition system.

-- Select Read Measured Values.

-- Select displayable measured value (4-cylinder engine) "IDE 00597" or long term adaptation of bank 1 mixture formation.

-- Follow the guided program.

-- Select displayable measured value (V6 and V8 engines) "IDE 00597" or long term adaptation of bank 1 mixture formation "IDE 00598" or long term adaptation of bank 2 mixture formation.

-- Press Complete .

-- Press Read .

-- Read the measured value or measured values.

NOTE:

If the bank 1 measured value or the bank 1 and bank 2 measured value differ by more than 15%, then additive G17 must be increased by a factor of 4. Refer to FUEL INJECTOR CLEANER G17 .

CAUTION:

If a deviation of > 15% is repeated, then a repair is necessary.