Vehicle Diagnostic Tester
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Warning information for the high voltage system:
For procedures where the ignition must be switched on, refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .
Special tools and workshop equipment required
- Vehicle Diagnosis, Testing and Information System :VAS 5051B
- Diagnostic Cable :VAS 5051/B1
- Vehicle Diagnosis, Testing and Information System :VAS 5052A
- Remote Diagnosis Head :VAS 5054A
- Diagnosis Interface :VAS 5055
- USB Bluetooth Adapter :VAS 5054/2
NOTE:
Make sure that the selected Vehicle Diagnostic Tester is only used with the matching cable.
WARNING:
- During a road test you must always secure testing and measuring equipment on the back seat.
- Drivers must NEVER operate these tools while driving.
-- Perform the following:
-- Connect diagnosis cable connector to data link connector.
-- Switch on the Vehicle Diagnostic Tester.
-- Switch on the ignition.
Follow the instructions appearing on the screen to start the desired functions.