Drive Head And Decoupling Spring, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Coolant Pipes And Bolts

Courtesy of AUDI OF AMERICA, LLC

Supercharger is secured to the Engine and Transmission Holder VAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .

-- Remove the coolant pipes from the compressor, refer to COMPRESSOR COOLANT PIPES, REMOVING AND INSTALLING .

-- Hold the supercharger perpendicular on the engine/transmission holder.

The drive head faces up.

-- Remove the bolts -arrows-.

Fig 2: Identifying Drive Head Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

Fig 3: Identifying Removal Of Drive Unit From Bearing Cap

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

To prevent the bearing cap -1- from coming and loose and having to be sealed again, do not use a hammer to remove the drive head -2- but rather use expanding pliers in direction of -arrows-, as illustrated.

-- Carefully remove the drive head from the bearing cap.

-- Remove the decoupling spring.

-- Extract all the oil for the compressor drive from the bearing cover as well as from the oil pockets -arrows- between the ribs using the Used Oil Collection and Extraction Unit SMN372500.

Fig 4: Identifying Oil Pockets -Arrows-

Courtesy of AUDI OF AMERICA, LLC