Overview - Cylinder Block, Belt Pulley Side, Vehicles with Electro-Mechanical Power Steering: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Block Exploded View (Belt Pulley Side, Vehicles With Electro-Mechanical Power Steering)
- Ribbed Belt
- Check for wear
- Do not kink
- Before removing, mark the running direction using chalk or a felt-tip pen.
- Removing and installing. Refer to Ribbed Belt, Removing and Installing, Vehicles with Electro-Mechanical Power Steering
- Ribbed belt routing. Refer to Ribbed Belt Routing .
- When installing, make sure it is seated correctly on the belt pulleys
- Ribbed Belt Tensioner
- To release tension on ribbed belt, pivot using a wrench.
- Secure using the Locking Pin - T10060A-
- Removing and installing. Refer to Ribbed Belt, Removing and Installing, Vehicles with Electro-Mechanical Power Steering
- Bolt
- 8 Nm + 45°
- Always replace after removing
- Bolt
- 150 Nm + 90°
- Always replace after removing
- Use the Counterhold - Vibration Damper - T10355- to loosen and tighten
- Coat the O-ring with engine oil
- O-ring
- Not a replacement part; supplied with the bolt -item 4-. See Fig 1.
- Vibration Damper
- With the ribbed belt pulley
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Sub-Assembly Bracket
- With oil filter and engine oil cooler
- Removing and installing the sub-assembly bracket. Refer to Sub-Assembly Bracket, Removing and Installing .
- Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Seal
- Always replace after removing
- Bolt
- Tightening specification and sequence. Refer to Sub-Assembly Bracket - Tightening Specifications and Sequence .
- Bolt
- Tightening specification. Refer to OVERVIEW - GENERATOR .
- Generator
- Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Alignment Sleeves
- For the A/C compressor
- A/C Compressor
- Do not remove or disconnect the refrigerant lines
- Removing and installing. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .
- Bolt
- Tightening specification. Refer to OVERVIEW - A/C COMPRESSOR POWER UNIT .