Left and right convertible top compartment cover locks, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove rear seat bench and backrest →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
.

CAUTION: Observe safety precautions when handling pyrotechnic belt tensioners →

69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS for BODY INTERIOR - CABRIOLET

Remove respective rear belt retractor →
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS
- 69 - PASSENGER PROTECTION - AIRBAGS, SEAT BELTS for BODY INTERIOR - CABRIOLET
.
Disconnect electrical connector behind belt retractor.

Fig 1: Bringing Convertible Top Into Center Position

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Bring convertible top into center position.
Remove securing clips for front convertible top compartment well trim until compartment locks are accessible.

Fig 2: Identifying Locking Washer, Push Rod & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove locking washer - 1 -.
Remove push rod - 2 -.
Mark exact position of bolts - 3 - and remove.
Remove convertible top compartment cover lock and lay it sideways,

Disconnect switch unit electrical connector and remove switch and lock.

NOTE:

The connection is located behind the belt retractor.

Installing

Installation is reverse of removal, noting the following:

Install bolts exactly at the markings made earlier. In this way, it is not necessary to adjust the locks.
Ensure the convertible top compartment cover aligns with the side panel when closed.
Check whether switch works with convertible top compartment cover closed.

Tightening torques → Convertible top compartment cover latch - assembly overview .