Hood, removing, installing and adjusting (up to model year 2005): Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Up to model year 2005
1 - Hood
- Removing:
- Disconnect line to windshield washer system and unclip line.
NOTE:
- A 2nd technician is needed to support and raise the hood.
- Remove gas-filled strut from hood → Gas-filled strut, removing and installing .
- Remove bolts.
- Remove hood.
- Install in reverse sequence.
- Adjusting:
- Align hood between fenders.
- Adjust height of hood at hood lock → Lower portion of hood lock, removing and installing .
- Hood can be adjusted for height relative to fenders by adjusting buffer stops Buffer stop for height adjustment .
2 - Hood hinge
3 - Screw
- 21 Nm
4 - Nut
- 21 Nm
5 - Gas strut
- Removing and installing → Gas-filled strut, removing and installing .