Hood cable, removing and installing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Hood cable
- Removing:
- Remove front wheelhousing liner → Front wheel housing liner, removing and installing .
- Remove storage compartment on drivers side (vehicles with knee bolster or Vehicles without knee bolster): →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for BODY INTERIOR - CABRIOLET
- Remove bolt.
- Remove retaining clip.
- Unclip cable for lower part of hood lock and disengage attachment lug - arrow A -.
- Remove cable from retaining clips opened earlier and pull into wheelhousing toward lock carrier.
- Install in reverse sequence.
- Bring ball on cable for lower part of hood lock into installation position.
2 - Operating lever
3 - Screw
- 2.4 Nm
4 - Retaining clamp
5 - Lower part of hood lock
- Removing and installing → Lower portion of hood lock, removing and installing .
- Can be used to adjust height of hood.
6 - Retaining clip