Windshield Spray Nozzles, Checking

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

If the Wiper Spray Nozzle Setting Tool :T40187 is not going to be used, then make sure both sides are covered and locked with the covers -3- and -4-.
If one side is not locked by the cover, it is possible to get injured by the needle -3125/5A- -item 1- or by the adjusting pin -2-.
When opening a side make sure the opposite side is not facing the hand.

Special tools and workshop equipment required

Wiper Spray Nozzle Setting Tool :T40187 equipped with Replacement Tip :3125/5 A

Fig 1: Identifying T40187, 3125/5A -1-, Adjusting Pin -2-, And Covers -3 & 4-
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Using a water-soluble marker, make marks on the windshield according to the table.

-- Mark positions on the inside of the windshield using water-soluble pen.

Fig 2: Identifying Spray Nozzles Adjusting

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The illustration is a schematic diagram. According to the table for the spray nozzle adjustment, the spray field may vary from the form shown where appropriate.

-- Compare the spray field with the marks and adjust if necessary. Refer to WINDSHIELD SPRAY NOZZLES, ADJUSTING .

Dimensions in mm		Driver's side	Passenger side
-a-	approximately	310	310
-b-	approximately	580	580
-c-	approximately	360	360
-d-	approximately	360	360
-e-	approximately	550	550
-f-	approximately	180	180