Windshield Spray Nozzles, Adjusting

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

If the Wiper Spray Nozzle Setting Tool :T40187 is not going to be used, then make sure both sides are covered and locked with the covers -3- and -4-.
If one side is not locked by the cover, it is possible to get injured by the needle -3125/5A- -item 1- or by the adjusting pin -2-.
When opening a side make sure the opposite side is not facing the hand.

Special tools and workshop equipment required

Wiper Spray Nozzle Setting Tool :T40187 equipped with Replacement Tip :3125/5 A

Fig 1: Identifying T40187, 3125/5A -1-, Adjusting Pin -2-, And Covers -3 & 4-
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unlock the long cover -1- on the Setting Tool:T40187 -arrow A- and push it toward the rear -arrow B-.

Fig 2: Identifying T40187

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the adjusting pin -2- on the spray nozzle -arrow- in the nozzle unit -1- and make a mark the positions on the windshield.

Fig 3: Place Adjusting Pin -2- On Respective Nozzle -Arrow- Of Nozzle Unit -1

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the spray field does not conform to the specifications, then clean the spray nozzle. Refer to appropriate service information. .