Overview - Shift Unit
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The 6-pin connector with backrest lock switch and backrest forward stop switch are not separate from the bracket. They are delivered as a >>microswitch with bracket << switch unit -item 7-.
The locking bushing -6- and screws for mounting the switch unit -2- are supplied as replacement parts.
Refer to Parts Information for part allocation.
For clarity, the backrest is shown without the cushion, cover and seat pan.
- Backrest Frame
- Bolt
- 1.5 Nm
- Quantity: 2
- Washer
- Nut
- Tightening specification. Refer to -item ) OVERVIEW - BACKREST ADJUSTMENT MOTOR - NUT
- Replace
- Shaft
- The threads must always be cleaned before installing the nut -item 4-, for example, using a thread tap.
- Coat the threads on the shaft with locking fluid before installing the nut. Refer to Parts Information for the locking fluid.
- Locking Bushing
- Clipped to the spindle
- Clip to the spindle after adjusting the switch unit
- Switch Unit (Microswitch with Bracket)
- Removing and Installing. Refer to BACKREST ADJUSTMENT MOTOR AND SHIFT UNIT, REMOVING AND INSTALLING .
- Adjusting. Refer to BACKREST LOCK SWITCH MICROSWITCH, ADJUSTING .
- Checking using the Vehicle Diagnostic Tester BACKREST LOCK SWITCH MICROSWITCH, CHECKING .