Bumper Cover, Removing And Installing, Except AUDI RS5: Removing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- If necessary, disconnect the electrical connector to the Outside Air Temperature Sensor -G17- and the electrical connectors to the front parking aid sensors. Refer to Parking Aid .
-- Remove the bolt -3- .
-- Remove the bolt -2- and the quick-release coupling -1- on the front bumper noise insulation.
-- Remove the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS5 .
-- Disconnect the electrical connector -1- on the fog lamp.
-- Remove the bolts -arrows- .
-- Disengage the side walls on the front side panel and remove the bumper cover forward.