Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

SET INTAKE MANIFOLD
1. Install the fuel vapor feed hose to the intake manifold.
2. Install the vacuum hose to the intake manifold.
3. Install the wire harness clamp bracket with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
4. Install a new gasket to the intake manifold.
5. Set the intake manifold on the engine assembly.
INSTALL FUEL DELIVERY PIPE . Refer to INSTALLATION [08/2013 - ] - Step 2
CONNECT FUEL TUBE SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 3
INSTALL INTAKE MANIFOLD
1. Temporarily install the intake manifold with the 6 bolts.
2. Tighten the 6 bolts in the order shown in the illustration.
  
  Fig 1: Identifying Intake Manifold Bolts Tightening Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
3. Connect the 6 wire harness clamps.
4. Connect the heated oxygen sensor connector.
5. Connect the No. 2 ventilation hose to the intake manifold.
INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR . Refer to INSTALLATION [08/2013 - ] - Step 1
INSTALL EGR VALVE ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 1
INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 18
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Refer to INSTALLATION [08/2013 - ]
INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to INSTALLATION [08/2013 - ]
CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
INSTALL LUGGAGE TRIM SERVICE HOLE COVER . Refer to INSTALLATION [08/2013 - ] - Step 3
INSPECT FOR FUEL LEAK . Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1