Selector Shaft Seal, Replacing

Procedure

Transmission installed

Vehicles with a TFSI Engine

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING 2.0L

-- Remove the noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Fig 1: Locating Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -1-, remove the air duct hose from the charge air cooler.

Fig 2: Identifying Clamps

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -2-.

-- Vehicles with a left auxiliary cooler: Free up the coolant hose -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness -1 and 2- from the air guide pipe.

-- Loosen the screw-type clamp -4-.

-- Remove the bolts -arrows- and remove the air guide pipe.

Vehicles with TDI Engine

Fig 3: Identifying Bolts, Clamp & Air Guide Pipe

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING 2.0L DIESEL

-- Remove the bolts -arrows-.

-- Loosen the clamp -2-, and remove the air guide pipe -1-.

All Vehicles

Fig 4: Elector Lever Cable Bracket Bolts And Locking Washer

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clip -2-.

-- Push the lock washer -3- upward and remove -arrow-.

-- Remove the selector lever cable from the transmission selector lever and pull it out of the cable bracket.

NOTE:

For better illustration the installed location is shown from behind.

Ignore -1-.

CAUTION:

Danger of damaging the selector lever cable.

Do not bend or kink the selector lever cable.

-- Remove nut -arrow-.

Fig 5: Identifying Selector Shaft Lever And Fastener

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pry the lever -A- off the selector shaft.

Fig 6: Pull Out Shaft Seal With A Small Screwdriver

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The selector shaft running surface could get damaged.

Position the screwdriver.

-- Pierce seal with a small screwdriver and pull out.

-- Coat outer circumference and sealing lips of new seal with transmission fluid.

-- Fill the space between the sealing- and dust lip -arrow- half way with sealing grease; sealing grease. Refer to the Parts Information.

Fig 7: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the seal using a 15 mm socket -1- until stop, while doing this do not tilt the seal.

Courtesy of AUDI OF AMERICA, LLC

The closed side of the seal -arrow- faces toward the outside.

-- Place the gearshift lever -A- on the shaft and fasten bolt -arrow-.

Fig 8: Identifying Selector Shaft Lever And Fastener

Courtesy of AUDI OF AMERICA, LLC

The transmission selector lever only fits to the splines in one position.

-- Press the selector lever cable onto the transmission selector lever and then adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

Tightening Specifications

Selector mechanism assembly overview. Refer to OVERVIEW - SELECTOR MECHANISM .
Charge air system; charge air system assembly overview. Refer to OVERVIEW - CHARGE AIR SYSTEM 2.0L or OVERVIEW - CHARGE AIR SYSTEM 2.0L DIESEL .
Air filter assembly overview air filter housing. Refer to OVERVIEW - AIR FILTER HOUSING - 2.0L DIESEL or OVERVIEW - AIR FILTER HOUSING - 2.0L .
Noise insulation; assembly overview - noise insulation. Refer to OVERVIEW - NOISE INSULATION .