Center Console with Standard Equipment

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Center Console

Courtesy of AUDI OF AMERICA, LLC

Center console securing bracket
- Removing and Installing. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .
Center Console Font Bracket
- Quantity: 2
- Removing and Installing. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .
Nut
- Quantity: 2
- 3.5 Nm
Cap
- Quantity: 2
- Push in the center console
Bolt
- Quantity: 2
- 1.5 Nm
Center Console
- Removing and Installing. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .
- Versions with storage net: adding the storage net in the new center console. Refer to STORAGE NET, ADDING IN THE NEW CENTER CONSOLE .
Bolt
- Quantity: 4
- 3 Nm
Liner Mat
Ashtray
- Equipped on some models
- Audi Logo on the ashtray cover is transverse to the direction of travel and ashtray can be used from the driver position
Gearshift Lever/Selector Lever
- Overview. Refer to the appropriate Controls, Housing article - Overview - Gearshift Mechanism .
Center Console Insert Decorative Trim
- Removing and Installing. Refer to CENTER CONSOLE DECORATIVE TRIM, REMOVING AND INSTALLING .
Coin Holder
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Removing and Installing. Refer to COIN HOLDER, REMOVING AND INSTALLING .
- Engage in the rear of the center console and press on it until it engages audibly.
Center Console Insert
- Removing and Installing. Refer to CENTER CONSOLE INSERT, REMOVING AND INSTALLING .
- Replace damaged or deformed clips
- Engage in the front of the center console and press on it until it engages audibly.
Clamp for Center Console Insert
- Quantity: 6
- Replace damaged or deformed clips
- Place in the insert
Cover for Clamp
- Quantity: 4
- Replace damaged or deformed clips
- Insert in the cover
Rear Center Console Trim
- Removing and Installing. Refer to CENTER CONSOLE REAR TRIM, REMOVING AND INSTALLING .
- Press on until it engages audibly
Bolt
- Quantity: 4
- 3 Nm
Rear Center Console Bracket
- Removing and Installing. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .
Bolt
- Quantity: 2
- 8 Nm
Storage Compartment
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Removing and Installing. Refer to FRONT CENTER CONSOLE STORAGE COMPARTMENT, REMOVING AND INSTALLING .
Bolts
- Quantity: 4
- 1.4 Nm
Nut
- Quantity: 4
- 8 Nm