Storage Net, Adding In The New Center Console

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pop Rivet Nut Pliers: VAS 5072A

Fig 1: Identifying Pop Rivet Pliers VAS 5072
Courtesy of AUDI OF AMERICA, LLC
Drill (angle drill or angle brace attachment)
3.5 mm diameter drill bit
Protective Eyewear

NOTE:

As an original component the center console is delivered without a storage net.

For vehicle versions with a storage net the storage net must be installed in the new center console, as described as follows.

Procedure

Courtesy of AUDI OF AMERICA, LLC

-- Lay the center console on a stable, clean surface.

WARNING:

There is a risk of eye injury.

Wear protective eyewear.

-- Stamp out the inner impressions -arrows- on the center console openings for the storage net 3.5 mm diameter, as shown.

-- Install the storage net. Refer to STORAGE NET, REMOVING AND INSTALLING .

-- Install the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .