Overview - Intake Manifold: Notes

Fig 1: Exploded View Of Charge Air System

Courtesy of AUDI OF AMERICA, LLC

Seal
- Always replace after removing
Alignment Pin
Bolt
- 8 Nm
Seal
- Always replace after removing
Bolt
- Tightening specification and sequence. Refer to Figure
Bracket
- For intake manifold
Bolt
- Tightening specification and sequence. Refer to Figure
Bolt
- Tightening specification and sequence. Refer to Figure
- Always replace after removing
Alignment Pin
Bolt
- 8 Nm
Intake Manifold with Charge Air Cooler
- The intake manifold with charge air cooler are one unit.
- Removing and installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Figure
- Always replace after removing
Charge Air Temperature Sensor After Charge Air Cooler -G811-
- 22 Nm
- Removing and installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
Gasket
- Always replace after removing
Connecting Piece
- For Throttle Valve Control Module -J338-
Charge Air Temperature Sensor In Front Of Charge Air Cooler -G810-
- 22 Nm
- Removing and installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
Bolt
- 10 Nm
- Not delivered separately
Coolant Pipe
- Not delivered separately
Bolt
- 10 Nm
- Not delivered separately
Coolant Pipe
- Not delivered separately
O-rings
- Not delivered separately
- Coat with coolant
Throttle Valve Control Module -J338-
- With Throttle Position Sensor -G69-
- Removing and installing. Refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .
O-ring
- Always replace after removing
Air Guide Pipe
Bolt
- Tightening specification -item 25) OVERVIEW - CHARGE AIR SYSTEM .
Bracket
- For Throttle Valve Control Module -J338-
Bolt
- 8 Nm
Bolt
- Tightening specification and sequence. Refer to Figure