Impact Member, Removing And Installing, Audi RS7: Removing

Fig 1: Identifying Impact Member, Audi RS6

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear bumper cover. Refer to REMOVING .

-- Remove the bolts -arrows-.

-- Tie up the bracket -1- with the central valve to the side.

-- Remove the spare tire well trim. Refer to SPARE WHEEL WELL TRIM, REMOVING AND INSTALLING .

Fig 2: Identifying Nut And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -2- and bolts -1, 4 and 5-.

-- Remove the impact member -3-.