Bumper Cover Lower Section, Removing And Installing, Audi RS7: Removing

Fig 1: Removing Sensors From Clips

Courtesy of AUDI OF AMERICA, LLC

-- Remove the mount for the tail pipe trim. Refer to REMOVING .

-- For vehicles with an automatic rear lid opener, disconnect the connector -1-.

-- Cut the cable tie -2-.

-- Remove the power rear lid opener sensor -3 and 4- from the clips -arrows-.

-- Release the tab -2- -arrow- while removing the lower section -1- from the bumper cover -3- at the same time.

Fig 2: Identifying Lower Section

Courtesy of AUDI OF AMERICA, LLC