Left Impact Member Mount, Removing And Installing: Installing

• Tightening specification. Refer to OVERVIEW - IMPACT MEMBER .

Install in reverse order of removal. Note the following:

-- Tighten the impact member mount according to the marking made during removal.

-- Install the condenser. Refer to CONDENSER, REMOVING AND INSTALLING .

-- Install the horn bracket. Refer to SIGNAL HORN BRACKET .

-- Install the left charge air cooling circuit cooler. Refer to FOR ENGINE(S) CTUA & CGXB - CHARGE AIR COOLING CIRCUIT RADIATOR, REMOVING AND INSTALLING or FOR ENGINE(S) CEUC & CRDB - CHARGE AIR COOLING CIRCUIT RADIATOR, REMOVING AND INSTALLING .

-- Install the connecting brace. Refer to INSTALLING .

-- Install the impact member. Refer to INSTALLING .

-- Install the front left wheel spoiler. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Install the front noise insulation. Refer to FRONT NOISE INSULATION, REMOVING AND INSTALLING .