Overview - Driver Side Airbag

Fig 1: Driver Side Airbag Exploded View

Courtesy of AUDI OF AMERICA, LLC

Locking Bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Removing and installing. Refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING, WITH MECHANICAL IGNITION LOCK or STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING, WITH ELECTRONIC IGNITION LOCK .
4-spoke Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
Wiring Set
- For Driver Airbag Igniter -N95-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
Driver Side Airbag
- with Driver Airbag Igniter -N95-
  WARNING:
  Follow all safety precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
3-Spoke-Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
Wiring Set
- For Driver Airbag Igniter -N95-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
Driver Side Airbag
- with Driver Airbag Igniter -N95-
  WARNING:
  Follow all safety precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .