Pistons, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is removed and secured to the engine/transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Mark the installation position and allocation:
- Pistons to cylinder
- Connecting rod to cylinder, refer to -item 4- (OVERVIEW - PISTONS AND CONNECTING ROD).
-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.
-- Remove the circlip -2- from the piston pin eye.
-- Remove the piston pin -3- using the :VW222A .
TIP:
If difficult to move, heat the pistons to approximately 60 °C (140 °F).
-- Remove the pistons -1- from the connecting rod -4-.