Engine, Securing To Engine And Transmission Holder
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Sling :2024A
- Holding Fixture :VW540
- Engine and Transmission Holder :VAS6095A
- Shop Crane :VAS6100
Procedure
- Transmission separated from engine. Refer to ENGINE AND TRANSMISSION, SEPARATING .
-- If equipped, release the retainer in direction of -arrow- and remove the engine cover mount -1-.
-- Engage the :2024A onto the engine and onto the :VAS6100 .
- To be aligned to the center of gravity of the assemblies, the mounting hook rail with holes must be inserted as shown.
CAUTION:
There Is a Risk of Injury from the Lifted Engine Falling.
Parts of the Body Could Be Crushed.
- Secure the mounting hooks and pins on the lifting tackle with a securing pin.
-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.
-- Tighten the :VW540 on the transmission side as shown on the engine with the bolts -arrows- and nut -2-.
-- Secure the :VW540 with mounting pin -3- and cotter pin -1- on the :VAS6095A .