Bumper Cover, Removing And Installing, Standard, ALLROAD: Installing

• Tightening specifications. Refer to OVERVIEW - BUMPER COVER, STANDARD .
• Install in reverse order of removal. Note the following:

-- When installing, the side catches on the guide piece -2- must engage completely into the bumper cover -1-

Courtesy of AUDI OF AMERICA, LLC

-- Fold the hinge on the guide piece forward and insert the bolt. Refer to BUMPER COVER, REMOVING AND INSTALLING, STANDARD, ALLROAD 

-- If equipped, connect the electrical connector on the Parking Aid Control Module -J446-. Refer to Parking Aid Control Module -J446-, REMOVING AND INSTALLING .

-- Install the tail lamp. Refer to TAIL LAMP, REMOVING AND INSTALLING .