Removing and Installing
Headlamp Washer System Spray Nozzle Cover:
Removing
-- Fold the washer nozzle cover -1- upward in direction of -arrow A-.
-- Using a screwdriver on the inner side, pry the spray nozzle cover -1- off the mount -2- in direction of -arrow B- and disengage it at the opposite side.
Installing
Install in reverse order of removal. Note the following:
-- Press the spray nozzle cover on until it engages audibly.
Spoiler Lip:
Removing
-- Remove the expanding pin -3- with the expanding clip -2-.
-- Remove the spoiler lip -1-.
Installing
Install in reverse order of removal.
Front Bumper Cover End Plate:
Removing
-- Remove the bolts -1- and -2-.
-- Pull the front bumper cover end plate back.
Installing
- Tightening specifications. Refer to OVERVIEW - BUMPER COVER, STANDARD .
Install in reverse order of removal.