Overview - Bumper Cover, Standard
- Bolt
- 3 Nm
- Bolt
- 1.5 Nm
- Bumper Cover End Plate
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING .
- Cover
- for the towing hook
- Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
- Right Front Parking Aid Sensor -G252-
- Removing and Installing. Refer to FRONT PARKING AID SENSOR, REMOVING AND INSTALLING .
- Radiator Grille
- Removing and installing. Refer to RADIATOR GRILLE, REMOVING AND INSTALLING, EXCEPT AUDI RS 4 .
- Bolt
- Tightening specification -item 7- OVERVIEW - RADIATOR GRILLE, EXCEPT AUDI RS 4 => List Item:Bolt .
- Lock Carrier Cover
- Removing and installing. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
- Expanding Rivet
- Remove the clamping pin when removing.
- Only press the clamping pin in when installing.
- Impact Absorber
- Removing and installing. Refer to IMPACT ABSORBER, REMOVING AND INSTALLING, STANDARD, ALLROAD .
- Left Front Parking Aid Sensor -G255-
- Removing and Installing. Refer to FRONT PARKING AID SENSOR, REMOVING AND INSTALLING .
- Front Bumper Cover Mount
- Removing and installing. Refer to BUMPER GUIDES, REMOVING AND INSTALLING .
- Bolt
- 4 Nm
- Nut
- 4 Nm
- Fog Lamp
- Removing and Installing. Refer to FOG LAMP .
- Air Intake Grille
- Removing and installing. Refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, STANDARD .
- Bolt
- 3 Nm
- Bolt
- 1.5 Nm
-- Tighten the bolts in the following order to 4 Nm -2, 3, 5, 1-.