SUBFRAME Mount, Checking Adjustment

WARNING: This page is about a different variant/trim than selected.

Procedure

-- Release the EVAP canister -B arrow-, remove it upward -A arrow- and lay it aside.

Fig 1: Releasing EVAP Canister -Arrow B-, Remove Upward -Arrow A-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1 and 2-.

-- Check dimensions on right mount for engine and transmission:

Fig 2: Checking Dimensions At Engine/Transmission Assembly Mounting

Courtesy of AUDI OF AMERICA, LLC

Both bolt heads -2- must be parallel to edge of engine mount support arm -3-.
A distance of -x- = 16 mm must be present between engine mount -1- and engine support -4-.

NOTE:

Distance -x- = 16 mm can also be checked with corresponding round stock.

-- The distance measured if too small or too large, adjust the subframe. Refer to SUBFRAME MOUNT, ADJUSTING .