Turbocharger Vacuum Diaphragm
WARNING: This page is about a different variant/trim than selected.
Removing
-- Remove the turbocharger. Refer to TURBOCHARGER .
-- Remove the linkage securing plate -2-.
-- Remove the nut -3- and the bolts -1-.
-- Remove the pressure hose -arrow- and the vacuum diaphragm.
Installing
- For the correct tightening specifications, refer to TURBOCHARGER OVERVIEW .
Installation is done is reverse order, observe the following:
-- Adjust the turbocharger vacuum diaphragm. Refer to TURBOCHARGER VACUUM DIAPHRAGM, ADJUSTING .
-- Install the turbocharger. Refer to TURBOCHARGER .