Dual Mass Flywheel

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

CAUTION:

Risk of destroying dual mass flywheel.

Remove bolts -B- by hand, not with and air-powered or impact wrench.
When removing bolts, ensure the bolt head does not come in contact with dual mass flywheel.
Rotate dual mass flywheel -A- so bolts -B- are centered to holes -arrows-.

Fig 1: Identifying Dual-Mass Flywheel & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Place the 3067 into the hole on the cylinder block -B-, remove the dual mass flywheel bolts.

Fig 2: Identifying Retainer -3067- Inserted In Hole On Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Installing

Installation is done is reverse order, observe the following:

NOTE:

Replace the dual mass flywheel bolts.

-- Place the 3067 into the hole on the cylinder block -item A-.