Seat bench cover and upholstery, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Bench Cover And Upholstery Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Cover

Removal:

Remove rear seat bench: Vehicles through 10.04 → Seatbench, removing and installing - vehicles up to 10.04 , vehicles from 11.04 → Seatbench, removing and installing - vehicles from 11.04 .
Pry out plastic strips - 3 - using a screwdriver.
Turn back cover - 1 -.
Remove cover - 1 - upward and press in plastic clips - 4 - (24x) using a screwdriver.

Pry out plastic strips - 5 -.

Installing:

Installation is reverse of removal. Observe the following when doing so:

Replaced damaged plastic clips.

2 - Upholstery

3 - Plastic strips (Qty. 24)

4 - Plastic clips (Qty. 24)

Replace damaged plastic clips.

5 - Plastic strips