Seatbench, removing and installing - vehicles up to 10.04: Notes

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Fig 1: Seatbench - Vehicles Up To 10.04 Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lift seatbench in - direction of arrow A - and pull forward in - direction of arrow B -.
Remove electrical harness connector for side airbag from groove Side airbag cable connector
Remove seat bench from vehicle.

Installing

Installation is reverse of removal. Observe the following when doing so:

CAUTION: Mountings must be replaced after each removal of seatbench Replacing mountings