Control module, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The control module for power seat with memory is located beneath the drivers seat.
With malfunctioning control module, the upper frame of seat pan with backrest must be removed → Front seat with malfunctioning motor for seat fore-aft adjustment or malfunctioning control module, removing .

Special tools, testers and auxiliary items required

Fig 1: Special Tool - Engine And Transmission Holder VAS 6095

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine and transmission holder VAS 6095

Fig 2: Fixture For Seat Repair VAS 6136

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fixture for seat repair VAS 6136

Removing

Remove seat → Front power seats with memory, removing and installing .
Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
Attach the front seat to the fixture for seat repair VAS 6136.

Fig 3: Identifying Bolts & Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - 2 - (2x).

Tightening torque: 1.5 Nm

Turn control module - 1 - around.

Fig 4: Identifying Retaining Bracket, Connectors, Catches & Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disengage retaining bracket - 4 - and disconnect connector - 5 -.
Press in catches - 3 - (2x) and disconnect connector - 2 -.
Remove control module - 1 -.

Installing

Installation is reverse of removal.