Seat pan, assembly overview
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- On the front seat, the upper and lower seat pan frames can be separated and replaced individually.
- When removing seat pan, ensure bushings in bearing points (upper and lower frame threaded connection) are not damaged. These bushings cannot be replaced with workshop materials.
1 - Screw, self-locking
- 28 Nm
- Qty. 3
- Replace
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
2 - Seat pan upper frame
- Removing and installing → Seat pan, disassembling and assembling
3 - Bushing
- Inserted in all bearing locations
- Cannot be replaced with workshop materials
- If bushings are damaged, assembly part must be replaced
4 - Seat pan lower frame
- Removing and installing → Seat pan, disassembling and assembling
5 - Screw
- 28 Nm
- Replace
6 - Nut
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
7 - Drivers Seat Height Adjustment Motor V245 or Front Passenger s Seat Height Adjustment Motor V246
- Removing and installing → Drivers Seat Height Adjustment Motor V245 or V246, removing and installing
8 - Seat Fore/Aft Adjustment Motor V288
- Cannot be removed and installed with workshop materials
9 - Drivers Seat Inclination Adjustment Motor V243 or Front Passenger s Seat Inclination Adjustment Motor V244
- Removing and installing → Motor for seat tilt adjustment, removing and installing
10 - Screw, self-locking
- 20 Nm
- Replace
- Threaded holes for screws must always be cleaned (for example, with thread cutter)