Brake Pedal And Mounting Bracket
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The path of the brake pedal must not be shortened via extra floor mats.
- Lubricate all bearing and contact surfaces with lubricant part no. Lubricant G 000 450 02.
- Mounting Bracket for Pedal Assembly
- Illustration for vehicles with automatic transmission.
- Removing and Installing, with Manual Transmission, refer to MOUNTING BRACKET, WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission, refer to MOUNTING BRACKET, WITH AUTOMATIC TRANSMISSION .
- Sleeve
- Brake Pedal Axle
- Bearing Pin
- Right Securing Clip (spring steel)
- Washer
- Gas Pedal Module Bolt
- 8 Nm
- Accelerator Pedal Module
- Pedal Support Bolt
- 20 Nm
- Brake Lamp Sensor
- Removing and Installing, refer to BRAKE LAMP SENSOR .
- Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position.
- Left Securing Clip (Spring Steel)
- Brake Pedal
- Removing and Installing, with Manual Transmission, refer to BRAKE PEDAL, WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission, refer to BRAKE PEDAL, WITH AUTOMATIC TRANSMISSION .WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- Mount
- For the ball head on the brake booster push rod.
- with ball stud retaining tabs.
- Removing and Installing, refer to BRAKE BOOSTER PLUNGER MOUNT .
- Nut
- 8 Nm
- StopWARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- Grommet
- Only installed on vehicles with automatic transmission.